help file - tiny sparrow RX
The Radical Wireless tiny sparrow TX (transmitter) and the tiny sparrow RX (receiver) support DMX/ RDM. Both are based on Lumenradio’s award winning CRMX technology.
The next lines will help you to set up the unit and get you through troubleshooting.
-> Start
-> UserInterface
-> Status LED
-> Technical Specs
tiny sparrow RX
User Interface & LEDs:
| link | button for link / unlink from a transmitter - to press use a small torx 5 or similar |
| power | Blue LED - lights up when power is connected |
| status | Blue LED - shows different states of status like: |
| linking, unlinking or receiving DMX signal | |
| signal | Red LED - lights up when the signal strength is under 10% or no signal at all |
| dmx | Green LED - lights up when receiving correct DMX |
function of the Status-LED
Receiver is not linked to a transmitter:
Receiver is linked to a transmitter, but no active radio link
Active radio link, no DMX data present:
Active radio link, DMX data present:
Technical Specs
| PowerIN | 6-36VDC range or USB (5VDC balanced - USB power banks are not fully supported) |
| power consumption | ~50mA |
| temp. working range | -20°C - +40°C |
| IP rating | IP20 |
| antenna connector | RP-SMA female |
| antenna | RP-SMA male, 2.5dBi |
| housing | ABS |
| connector | 2pin male Phoenix PTSM |
DMX
| DMX OUT | DMX512-A (ANSI E1.11) and RDM (ANSI E1.20) compatible |
| connector | 3pin male Phoenix PTSM |
Downloads
| datasheet & manual | tiny sparrow RX - ENG - v1.2 |